example

ELECTRICAL RELAYS

•

IP54 protection rating

• Intelligent battery combiner relay, which automatically detects the voltage of the system • In the case of more than one battery in the system, the accessory battery (and others if applicable) would be connected to the starter battery with Victron battery combiners • Virtually no voltage loss so the output voltage of alternators or battery chargers do not need to be increased • Will dis-engage if temperatures get too high to prevent damage, and will re-engage once it has cooled down

VC CYR010120011

ELECTRICAL

Part no.

Volts

Amps 120A 230A

Height mm Width mm Depth mm

VC CYR010120011 12V VC CYR010230010 24V

46 65

46

80 50

100

VC CYR010230010

SWITCHING RELAYS Use these relays to operate heavy consumption accessories via lower rated switches.

Part no. 714851 714852 714855 714870 714876

Voltage 12V DC 24V DC 24V DC 12V DC 24V DC

Type

60 amp 4 terminal 33RA type 40 amp 4 terminal 33RA type

714851

714852

40 amp heavy duty 4 terminal 33RA type

30 amps normally open, 20 amps normally closed switching 20 amps normally open, 10 amps normally closed switching

714876

RELAYS

PUSH / PULL DC SOLENOIDS

Part no.

Voltage

Amps

Pins

Murphy push / pull DC solenoids provide single unit versatility for engine applications, such as engine shutdown solenoids. Supplied with return spring and rubber seal boot. • No internal switches • Reduce coil burnout • One solenoid for pull / push operation • Use for energised to stop or energised to run (with relay solenoid)

Mini

714801 714805 714807

24V 12V 24V

22A

4 5 5

714805

40 / 15A 22 / 10A

Heavy Duty

714825

24V - Heavy Duty High Performance 60A

306008

714827 714828

12V 24V

100A 100A

- -

Part no.

Murphy part no.

Voltage

Maximum stroke mm (inches)

Holds up to pounds / N

714825

Micro

306007 306008 306009 306010

RP-2307B 12V DC RP-2308B 24V DC RP-2309B 12V DC RP-2310B 24V DC

25 (1”) 25 (1”)

23 / 102 23 / 102 34 / 151 34 / 151

714835 714837

12V 12V

20 / 10A

5 4

22A

38 (1-1/2”) 38 (1-1/2”)

714837

The mounting screw hole can be easily removed if it is not required.

SD85 SOLENOID RELAY

306021 The Murphy RPS inline ball joint is suitable for use with push / pull solenoids. The inline ball joint features a 1/4”-28 UNF female thread and has an overall length of 51mm (2”).

306021

306026 The Murphy clevis yoke is suitable for use with push / pull solenoids. The stop solenoid clevis yoke features a 1/4” UNF female thread and measures 28.1mm long with a 16mm outside diameter jaw and a 2mm pin.

306085

306085 The SD85 is used when the solenoid is duty cycled for short time periods. It activates both coils of the solenoid for a short time and then de-energises the ‘energise’ coil. Typical application would be on energised to run solenoids, where the SD85 is used to prevent premature solenoid coil burn out.

306026

59

info@asap-supplies.com

www.asap-supplies.com

01502 716993