AG Publications Nova Leisure Catalogue 2021

Electrical, Lighting & TV -

Inverters & Chargers - Victron

Victron Multiplus 24/3000/70 Combi Inverter Charger (16A Relay) Pure Sine Wave, Output 6000,Watt Peak Power, 2500 Watt / 3000 VA Continuous, 70 Amp Battery Charger, 4A Float charge for starter battery, 16 Amp Power transfer Switch Power Assist Dimensions (H x W x D) mm: 362 x 258 x 218, Weight: 18kg. Ready for parallel operation. 24 Volt. VV-027

Victron Easyplus 12/1600/70 Combi Inverter Charger Like the Victron Multiplus, the 'Easyplus' is a multi-functional combined inverter/charger, but with the added benefit of pre made wiring and built-in RCD and MCB's, eliminating the need for an external AC distribution unit. Ideal for smaller systems, particularly where space may be limited, and also saving time during installation. • Pure Sine Wave • Output. 3000 Watt Peak Power • 1600VA Continuous Power • 70 Amp Battery Charger • 4A Float charge for starter battery • 16 Amp transfer Switch Power Assist • Dimensions (H x W x D) mm: 510 x 214 x 110 • Weight: 11.7Kg • Includes RCD (30mA/16A), 2 x MCB (16A) VV-007

Victron Multiplus 24/3000/70 Combi

The MultiPlus Combo from Victron is a powerful true sine wave inverter and sophisticated battery charger featuring adaptive charge technology and a high-speed AC transfer switch in a single compact enclosure. The unit’s unique PowerAssist feature prevents overload of a limited AC source. Firstly, battery charging will automatically be reduced when otherwise an overload would occur. The second level will boost the output of a generator or mains hook up supply with power taken from the battery. In the event of a grid failure or shore or generator power being disconnected, the inverter is automatically activated and takes over the supply to the connected loads. This happens in less than 20 milliseconds so that computers and other electronic equipment will continue to operate without disruption.

Up to six Multis can operate in parallel to achieve higher power output. Three phase or split phase operation is also possible. NOTE: Please check Victron datasheets to see which models have paralleling, three-phase and split phase capabilities.

Inverter: • Input voltage range: 19 - 33VDC • Continuous output power at 25 °C: 3000VA • Peak power: 6000W • Maximum efficiency: 94% • Zero-load power: 15W

Charger: • AC input: 187-265VAC 45-65HZ • Charger current: 70A • Starter charger: 4A • AC relay: 16A VV-036

Victron VE.Bus BMS Battery Management System

Victron BMS 12-200 Battery Management System

This unit is a protective device that acts as the hub and safety net for your Lithium system. It connects to Victron's lithium batteries and enables the entire battery bank to be protected against over/under voltage and over temperature.

This unit is a protective device that connects to Victron's lithium batteries and enables the entire battery bank to be protected against over/under voltage and over temperature. It connects to the daisy-chain connectors on the batteries, and between the starter and domestic battery where an alternator is being used for charging.

It connects to the daisy-chain connectors on the batteries which enables it to monitor each cell individually. It also connects to a Victron Multiplus, Quattro, Phoenix inverter or Phoenix charger via an RJ45 data cable. It is also used to control a Cyrix Li-ct or a Cyrix Li-charge relay to disconnect the charger/load in the event of under/over-voltage and over temperature. In a deep discharge situation the VE Bus connection enables loads to be disconnected via Victrons "Battery Protect" before the battery becomes discharged so deeply that the BMS needs to disconnect it, that level can be set with a BMV.

The device's purpose is to protect the Li-ion batteries in the event of under/over-voltage and over-temperature by electronically disconnecting them when the charge voltage is too high or the battery voltage becomes too low. It limits the charge power from the alternator to prevent overheating, particularly while running on lower rpm and will also prevent the Li-ion battery discharging into the starter battery to prevent excessive discharge. It also prevents the load from taking power from the starter battery.

NOTE: This product is specific to lithium installs.

NOTE: This product is specific to lithium installs.

VV-160

VV-162

Nova Leisure Unit 1-5 Century Park industrial Estate, Ballin Road, Nuneaton, Warwickshire, CV10 9GA

118